Model EZ-3200 Weigh Feeder and Process Controller

A Four Slot Rack can be configured to run one or two Weigh Belts, Belt Scales or Loss In Weight Feeders depending on I/O Requirements.

A Six Slot Rack can be configured to run one or up to four Weigh Belts, Belt Scales or Loss In Weight Feeders depending on I/O Requirements.

The EZ-3200 O/I
Provides an easy to use operator interface for the EZ-3200 series
of instruments. It is used to calibrate, control, monitor and perform
diagnostics routines on any device in the module rack.
Specifications:

4 x 20 Vacuum Fluorescent Display.
Key presses are both tactile and audible.
Numeric Keys for numeric entries.
Electrical Interface: 4 wire RS-232 RXD, TXD, RTS, CTS, Handshaking can be disabled.
Communication: 300-600-1200-2400-4800-9600 baud
Data Bits: 7-8, parity even-odd-mark-space-ignore
All parameters are held in non-volatile EEPROM

Graphics Display
The GDP is an intelligent operator interface specifically designed to work with the advanced line of EZ-3200 instrumentation developed by Thayer scale. Once properly configured and attached to a THAYER net II communication network, the GDP can be used to calibrate, control, monitor and perform diagnostics routines on virtually any device in the network. The large backlit LCD display screen makes viewing the information very easy.

COMMUNICATIONS
The AP 32HS Host port provides a means for external devices (hosts) such as programmable logic controllers (PLC), computers or distributed control systems to exchange information with an EZ-3200. This port supports both RS-232 point-to-point and RS-485 multi-drop operation. The application software running within the AP32HS determines the type of information that is available.

[ page 1 ] [page 2] [page 3]